Dagu DGServo 9g (Pan and tilt)
Dagu DGServo 9g (Pan and tilt)
The breadboard view is rendered as non-perspective top projection for layout on stripboard or similar.
The inner circle indicates the turning circle of the base of the pan and tilt frame at about 16mm above board level if you fully recess the motor, 33mm if not.
The outer circle indicates the turning circle of the tilt part of the frame when at its greatest extent (41mm) at about 50mm if recessed, 67mm if not.
Further allowances will need to be made for any electronics mounted to the tilt frame.
The female header connector normally attached to end of the servo wires, exists in Fritzing as a separate part in the Dagu bin. Simply plug the connector onto whichever header pins you are using, then attach the wires to the connector.
The breadboard view is rendered as non-perspective top projection for layout on stripboard or similar.
The inner circle indicates the turning circle of the base of the pan and tilt frame at about 16mm above board level if you fully recess the motor, 33mm if not.
The outer circle indicates the turning circle of the tilt part of the frame when at its greatest extent (41mm) at about 50mm if recessed, 67mm if not.
Further allowances will need to be made for any electronics mounted to the tilt frame.
The female header connector normally attached to end of the servo wires, exists in Fritzing as a separate part in the Dagu bin. Simply plug the connector onto whichever header pins you are using, then attach the wires to the connector.
100%
Connectors / Pins — 3 total
Download .fzpz
Module ID
Dagu_DGServo_9g_Pan_and_tiltCategory
ElectromechanicalAuthor
Stephen Parry