Retrocube Case for Raspberry Pi 5

I started with the original model by Uncle_Gru for my Pi 3, and when I got the Pi 4, I used that one. Couldn't find one for the Pi 5, so I did the best I could to modify it. All the credit goes to Uncle_Gru for the Retrocube. All I did was modify it so I could use it with my Raspberry Pi 5. (I lost a couple of the slats on one side, but feel free to figure out how to fix that if you really think it needs them.) The two lids posted were brought over from the two Retrocubes that Uncle_Gru posted and I had nothing to do with them except repost them.

Please see either of the original Retrocubes for printing instructions such as infill, etc.

It's a tight fit, but mine worked fine after I made a small filing on the top of where the button sits, on the inside, so it would go in smoothly. As I said, all the credit goes to the original poster, Uncle_Gru. Thank you Uncle_Gru for a wonderful design.