DJI Action 3 4 5 Dual Camera Case with room for 2 Camera's and upto 4 Batteries/Mag Mount and upto 4 MicroSD card's

The Case I used for this. I can not remember where I got it from, But it said it was for the Action 5 and was a round screw type case with a screw on lid

I own two Camera's the Action 3 and 4, So i wanted to make a Case for all of them, As I do not know how to do Cad, I used Tinkercad to cut the case up and make it into what you see here, You cannot leave any lens protection on the lens when putting it in this case, as you can see from the pictures, You can just place it around a battery

The battery section, if you put the mag mount into one, make sure it is not next to the Micro SD card's as it will probably destory your cards

I printed the case at 15% infill and the lid at 100% infill. I had to run a blade around the case and lid to get it to fit as it was tight. does not take much "Shaving" to do it, but needs doing, unless you resize it a tiny bit before printing, Depends on your Printer and Filament quality

Also I added a small bit of foam so it gives it a little bit of protection, I had to cut the sections out where the catch is on the frame.

The frame has to be fitted so it fits without been loose in the case