USB-C Board Mount

I like to dabble in the electronics world. Getting the electronic parts, PCBs to fit easily into an enclosure is always a process. So I create these mounts that can be glued in place and the PCB/part can be inserted after it is wired.

This is a mount for the Lonely Binary USB-C (USB-C Breakout Board 5.1K Resistor DIP for ESP32 ). It has screw holes for an M3x6 screw to secure it. However, it's a tight fit, so it may not be necessary. The hole on the board is 4.8mm so not quite an M5 size, but even an M4 may have too big of a head to fit next to the female USBC connector. So I opted for offset M3 screws catch the edge under a smaller M3 head.