Darwin Baby Ape Camera Mount

this is just a extender for the darwin baby ape pro v2 (could work with other version but mine is v2) so you can add more angle to your fpv camera. the frame would block the camera for have a higher degree so i just made this mount to extend the camera so you can have all the way up to ~90 degrees. it also is not terrible for protection, i crashed full speed into a bench and it took most of the impact and protected my camera, you can see the damage in one of the pictures. lmk if you have any suggestions on what i should add, thanks. also, PLEASE leave a comment below to let me know if it works with other version besides the v2.

Print Details:

Infill = %100

Filament:

Basic PETG (recommended)

(it should work with most filaments as long as it is not too brittle because you will have to flex the print to fit it around the frame.)