This part is licensed under Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International (CC BY-NC-SA 4.0). https://creativecommons.org/licenses/by-nc-sa/4.0/

Part of the ExoBass project — full catalog, build planner, and assembly guides at https://exobass.com

Plan Your Build & Get Hardware

ExoBass can be confusing! Head over to our Build Sheet - https://exobass.com/build-sheet - to plan your entire build - it'll walk you through every available part and handle compatibility along the way, and it covers all ExoBass parts. It's also the best way to get hardware, since it lets you buy everything for a full build in one go, not just this part.

You can find this specific part, ExoBass - Extras - Sanding Jig, on our site: https://exobass.com/part/extras/sanding-jig/2751ac73-5555-5539-8f66-4a73f8fdf69c

Step 1: Apply sandpaper tape

Peel the backing from the Sandpaper Tape - 2-3/4in - 400 Grit (listed in the BOM) and stick it to the flat working face of the fret sanding jig. Press from the center outward so the tape lies smooth, with no bubbles or folded edges.

Hardware

DIY Kit

You can order a DIY kit for your entire build from https://exobass.com/build-sheet , the estimate for this part's kit is $0.34 plus shipping.

Self Source

If you want to order the parts yourself, here's a list. Estimated cost: $14.99.

• 1x Sandpaper Tape - 2-3/4in - 400 Grit