WACCA Cabinet Face Cooling 120mm Fan Mount

Allows to mount a 120mm fan where the smartphone clip bracket would have normally been mounted instead.

Print the body and optionally the grill parts from the original thing at https://www.thingiverse.com/thing:7176580

But for the base and arm, print the parts from this post.

In the pictures I am using a 20cm arm, but you might wanna use a 25cm one depending on your preferences.

Note that your fan must be lightweight enough for the arm not to snap.

A San Ace 120 is the maximum I would say as the arm bends quite a bit, but it also has decent airflow.

This issue might be on me as I printed with PLA, not PETG.

I swapped it for some other Coolermaster fan in the end as that was significantly lighter.

Wiring is left up to users' discretion. I tapped off 12V on one of the HDD power connectors inside the cabinet.