DIN Case for Waveshare Raspberry Pi 8-ch Relay Expansion Board

An ordinary case for the Waveshare 8 Relais Raspberry HAT.

The original plan was to print clear poles, and let the LED lights on the PCB shine out through the front of the part, it printed very well but my filament was not clear enought, there was barely any light shining through, maybe someone else wants to try it.

Also, you have to use counter sink screws and accually have to counter sink the back of the PCB a little bit, because otherwise, it wont be able to slide in the original

DIN Rail holder, but that doesn't harm at all because there are no traces arround the Screw holes.