Parkside x20 Battery case

This is a battery case for Parkside x20 machines , for 18650 batteries and circuit board... or 150 grams of sugar sweetener XDXDXD

there's no need for supports, the model was prepared for "bridges".

not intend to be a replica of original case , this was made to be simpler to print.and diy.

.

note:glue the tip end of the CLIP in its specific place.

.

for mini voltmeter model use one in foto , very common (fits great no glue required)

probably its better to mount a test button to check the voltage (there's a determined place for it just need to cut the hole)

.

.

the Parkside batteries are fairly cheap to get ,making a battery will probably get more expensive than 17 euros.

.

Notice!! In order to work in the parkside machines besides plus and negative you must use a 10k resistor between the negavive and the (T) terminal (to by-pass the termistor)

Use a bms to control the charge

UPDATE : 31/10/2020

More models available up to 5x3 cells

I update the TOP part to a new female terminal ive been using (much Stronger)

link:

https://pt.aliexpress.com/item/4000501759991.html?spm=a2g0o.detail.1000013.5.1b10ddc6SLgA3r&gps-id=pcDetailBottomMoreThisSeller&scm=1007.13339.169870.0&scm_id=1007.13339.169870.0&scm-url=1007.13339.169870.0&pvid=8cbb1f36-e71f-409f-9abc-3c906b320f8f&_t=gps-id:pcDetailBottomMoreThisSeller,scm-url:1007.13339.169870.0,pvid:8cbb1f36-e71f-409f-9abc-3c906b320f8f,tpp_buckets:668%230%23131923%2364_668%23808%234094%23180_668%23888%233325%231_668%234328%2319937%23796_668%232846%238107%2332_668%232717%237566%23816_668%231000022185%231000066058%230_668%233468%2315618%23945

please feedback , all comments are welcome.